Dalian Huarui Heavy Industry CNC Equipment Co.,Ltd.
36
It is necessary to fasten and replace.
3) Check if all drive part has become adrift, and if the gear and rack have inosculated. It is
necessary to adjust if the occasion should arise.
4) Check if the operation plate and fastening screw have adrift, the dust inside cabinet will
be cleaned by the vacuum and the blower. And check if the connector lug has adrift.
Appendix A hardware specification
17"LCD Display
。
40GB(or bigger storage)Hard Disk
、
1.44MB Floppy Driver
、
USB Port and DVD driver
2.4GHz
(
or higher
)
Celeron
。
.
256MB
(
or higher capacity
)
Memory.
More than 64 interfaces signal wires for cutting and actuating logic signal (gas control,
tracking system, marking apparatus, restoration ECT)
,
it mainly depends on I/O disposition.
Technical grade crust package and keyboard design weaken interference of RFI/EMI
。
Technification of Surface Mount PCB.
Both of the axles use optoelectronic isolating plus-minus 10VDC output command pulse
and incremental encoder input. It can extend 6 axis movements. If using SERCOS interface
can control the movements of 12 axis and 1024 I/O points. And the increased moving axis
can control the work of doubling piece, of doubling lateral direction, of CBH, of doubling
revolving, of doubling beating or of 8 Sensor
TM
THC
+5VDC
single-ended input or differential coder input.
optoelectronic serial communication rate reach to115 Baud Rate ,it can reach to
230 Baud Rate if you use controller own communication link software
multiple power source input
(
100-240VAC
;
47-63Hz
)
Operating environment:
0—50
cent degree
(
32-122F
)
;
95%
relative
humidity (none
condensing).
Mariner controller
apologetic cooling equipment.