17
Transporting
If the pumpset has been used, allow it cool for
at least 15 minutes. A hot engine and exhaust
system can burn you and can ignite some
material.
When transporting the
, turn the
engine
switch and fuel
cock to the OFF position,
and keep the
to
reduce the possibility of the fuel leakage.
pumpset
pumpset on a level surface
STORAGE
1. Be sure the storage area is free of excessive humidity and dust.
2. Unscrew the fuel tank cap, remove the fuel strainer, and empty the fuel (petrol and
kerosene, both). We recommend using a commercially available petrol hand pump to
empty the tank. Reinstall the fuel strainer and the fuel tank cap.
3. Drain the fuel
Remove the Oil pan of Air cleaner, and empty it and reinstall.
Petrol is highly flammable and explosive You can be
burnt or seriously injured when
handling fuel.
•Stop the engine and keep heat, sparks, and flame away.
•Handle fuel only outdoors.
•Wipe up spills immediately.
5. Change the engine oil
6
tablespoon of clean engine oil into the cylinder.
Crank the engine several revolutions to distribute the oil, the reinstall the spark plug.
. Remove the spark plug and pour about a
7
felt.
. Slowly pull the starter grip until resistance is
8
pumpset
and cover it properly.
. Store the
in clean area
4.
TRANSPORTING & STORAGE
At this point, the piston is coming up on its compression
stroke and both the intake and exhaust valves are closed.
Storing the engine in this position will help to protect it from
internal corrosin. Return the starter grip gently.
Turn the fuel cock to the ‘START’ position.
Open the drain cock and drain the Petrol
from the carburetor.
Turn the fuel cock to ‘RUN’ position.
Open the drain screw and drain the petrol from the carburetor.
After all the fuel has drained, close the drain cock
(in WBK 30 and WPK 20)
or tighten the
carburetor drain screw securely
(in WB 30 and WP 20)
and turn the fuel cock to STOP position.
c.
Place a suitable container under the drain tube.
a.
In WBK 30 and WPK 20 -
In WB 30 and WP 20 -
b.
