2007 ST1300/A
6
©2007 American Honda Motor Co., Inc. – All Rights Reserved
5. Remove the motorcycle from the
crate base (cont.).
Remove the shipping braces, nuts, and
protective covering from the foot pegs on
both sides of the motorcycle.
Lift the motorcycle free from the crate base
and remove the base.
On a firm, level surface, lower the sidestand
and lower the motorcycle until it is resting on
its rear wheel and sidestand.
6. Install the front fender.
Remove the axle bolt.
Remove the axle protective covering and the
axle shaft.
Position the front reflector stays on the inside
of the front fender by aligning them with the
projections on the front fender. Install the
front reflector stays with two 6 x 20 mm pan
screws and rubber washers.
Secure the reflectors to the stays with two
6 mm flange nuts.
Torque the nuts.
Torque: 12 N·m (1.2 kgf·m, 9 lbf·ft)
Position the front fender between the fork
legs and attach it to the fork stays with two
6 x 18 mm socket bolts. Secure the brake
hose stays with two 6 x 16 mm flange bolts.
Torque the bolts.
Torque: 12 N·m (1.2 kgf·m, 9 lbf·ft)
PARTS
QTY
Front fender
1
Rubber washer
2
Pan screw 6 x 20 mm
2
Socket bolt 6 x 18 mm
2
Flange bolt 6 x 16 mm
2
Front reflector
2
Front reflector stay
2
Flange nut 6 mm
2
PROTECTIVE
COVERING
(discard)
SHIPPING
BRACE
NUTS
PROTECTIVE
COVERING
(discard)
AXLE SHAFT
AXLE
BOLT
FORK STAY
LOWER
REFLECTOR
FRONT
REFLECTOR
STAY
RUBBER WASHER
FORK STAY
UPPER
6 x 18 mm
SOCKET BOLT
6 x 20 mm
PAN SCREW
6 x 16 mm
FLANGE
BOLT
6 mm
FLANGE
NUT
