54
OPERATION
Do not turn the mode selector switch to another position while the snow blower is
moving. The electronic control unit will interpret this as a failure; the snow blower
will stop moving and the auger will stop turning.
When the snow blower and auger stop moving/turning, move the main shift lever to
the N (neutral) position, release the drive clutch lever.
Check each part to verify it is in its proper position before resuming operation.
3a. Clearing in AUTO mode
Setting the mode selector switch at the AUTO position can simplify
clearing the snow. AUTO mode keeps the auger from rising, adjusts the
engine speed automatically, etc.
1) Operate the chute control switch to
adjust the snow discharge direction and
angle (see page 27).
2) Operate the auger housing control
switch to adjust the auger to be parallel
to the road surface (see pages 50 and
52).
USA model only:
• You can return the auger to the initial
position by pushing the reset switch.
• If you return the auger to the initial
position by pushing the reset switch, the
auger can hit against the road surface or
can be raised from the road, resulting in
some snow left on the ground,
depending on the road condition and
the position of the snow blower.
Adjust the auger height position as
needed.
CHUTE CONTROL SWITCH
RESET SWITCH (USA
model only)
AUGER HOUSING
CONTROL SWITCH
31V156250.book 54 ページ 2020年12月22日 火曜日 午後1時36分
Содержание HS1336i
