Honda HRN536CVKEA, Руководство пользователя

Страница: 4 / 132

4
ENGLISH
SETUP
UNPACKING
Remove all the cardboard from around the handlebar.
HANDLEBAR SETUP
Turn the handlebar adjust knobs into the unlocked position, and then
carefully raise the handlebar into the mowing position

. The VKEA
type requires the cutting-means control lever

to be pulled against
the handlebar.
Align the adjust knobs with one of the two holes on each handle stay.
Setting the adjust knobs in the lowest holes raises the handlebar to its
highest position.
Turn the handlebar adjust knobs 90 degrees into the locked position,
making sure both sides are positioned at the same height.
NOTICE
Do not allow the control cables to become caught, pinched, or kinked
while unfolding the handlebar. The cables or engine control system
may be damaged.
GRASS CATCHER ASSEMBLY
1. Install the assembled frame [1] into the fabric grass catcher [2],
keeping the grass catcher handle [3] exposed.
2. Secure the seven plastic clips [4] to attach the fabric catcher to
the frame.
Lift the discharge
guard [1] and install
the grass catcher [2].
ENGINE OIL
The mower is shipped WITHOUT OIL in the engine.
Add enough SAE 10W-30 API
service category SN or later
oil to bring the oil level
between the upper limit [2]
and lower limit [3] marks on
the dipstick [1] as shown.
Do not overfill the engine
with oil
. If the engine is
overfilled, the excess oil may
get transferred to the air
cleaner housing and air filter.
FUEL
Refer to page 7.
BEFORE USING YOUR LAWNMOWER
Before using the lawnmower, all mower operators must read the
following chapters:
• SAFETY INSTRUCTIONS (page 2)
• CONTROLS (page 5)
• PRE-OPERATION CHECKS (page 6)
• OPERATION (page 9)
• MAINTENANCE SCHEDULE (page 12)
2
1
HANDLEBAR
ADJUST KNOBS
UNLOCKED
LOCKED
[2]
[3]
[4] (7)
[1]
[2]
[1]
[1]
[3]
[2]