Honda HRN216VKU, Руководство пользователя

Страница: 16 / 24

16
Removing From Storage
When unfolding the handlebar, be sure to lock the handlebar adjust
knobs to secure the handlebar in the mowing position.
Check your mower as described in BEFORE OPERATION ( page 4 ).If
the cylinder was coated with oil during storage preparation, the engine
may smoke briefly at startup.
If the cylinder was coated with oil during storage preparation, the
engine may smoke briefly at startup.
TROUBLESHOOTING
Engine Will Not Start
Loss of Power
Vibration
Mowing and Bagging Problems
Possible Cause Correction
Blade control not engaged Hold blade control lever against the
handlebar (
page 3 ).
Fuel valve OFF Turn the fuel valve ON ( page 3 ).
Out of fuel Refuel ( page 7 ).
Bad fuel; mower stored
without treating petrol, or
refueled with bad petrol Refuel with fresh petrol ( page 7 ).
Spark plug faulty, fouled, or
improperly gapped Gap or replace the spark plug
(
page 14 ).
Spark plug wet with fuel
(flooded engine) Dry and reinstall the spark plug.
Fuel filter clogged,
carburetor malfunction,
ignition malfunction, valves
stuck, etc. Take the mower to an authorised
Honda servicing dealer for repair.
Possible Cause Correction
Grass is too tall Raise the cutting height ( page 6 ), cut
a narrower swath, use a slower
ground speed, or cut more frequently.
Instead of mulching, try rear
discharging or bagging.
Mower deck is clogged Clean out the mower deck ( page 15 ).
Air filter is clogged Clean or replace the air filter
(
page 13 ).
Bad fuel; mower stored
without treating petrol, or
refueled with bad petrol Refuel with fresh petrol ( page 7 ).
Fuel filter clogged,
carburetor malfunction,
ignition malfunction, valves
stuck, etc. Take the mower to an authorised
Honda servicing dealer for repair.
Possible Cause Correction
Grass and debris lodged
under the mower deck Clean out the mower deck ( page 15 ).
Blades loose Tighten loose blade bolts ( page 12 ).
Blades bent, damaged, or
unbalanced by improper
sharpening Take the mower to an authorised
Honda servicing dealer for repair.
Mechanical damage, such
as a bent crankshaft
Possible Cause Correction
Mower is moving too fast
for lawn conditions Apply less pressure to the Smart
Drive paddles.
Mower leaves behind cut
grass when bagging Grass bag may be full. Empty the
grass bag.
Cutting height adjustment
levers set at different
positions Set all levers at the same cutting
height position (
page 6 ).
Grass bag clogged Wash the grass bag ( page 15 ).
Grass bag full Empty the grass bag.
Mower deck is clogged Clean out the mower deck ( page 15 ).
Blades dull, worn, or
damaged Sharpen or replace the blades if
necessary (
page 12 ).
Wrong blades installed Install correct blades ( page 20 ).