Honda HRM300/500, Руководство пользователя

Страница: 15 / 70

13
3 PREP
ARA
TION
Installation
Conditions for laying the boundary wire
Image Condition
Height of objects which the
lawnmower might run on top of
Lay boundary wire around objects which the
lawnmower might run on top of; these objects
must be removed from the work area.
Maximum
5 mm
interval
Overlapped Crossed
The boundary wire entry and exit points for a
round area should be separated by less than 5
mm. (However, the boundary wire should not
overlap or cross itself.)
30 cm to 50 cm
There must be 30 cm to 50 cm of space
between the boundary wire and large objects.
(This space can be reduced to as low as 30
cm if you set [Wire Overlap] to a low value. For
details, consult your dealer.)
More than
10° (17%)
Less than
10° (17%)
Do not lay boundary wire so that it intersects on
a slope of more than 10° (17%).
You can lay boundary wire parallel to a slope of
more than 10° (17%) in order to access an area
with a slope of less than 10° (17%).
Boundary wire should be laid so that there is no
excess wire.
Radius
30 m
The lawnmower can detect the signal from the
boundary wire within a 30 m radius.
If the lawnmower enters a space inside the
work area with no boundary wire within a 30 m
radius, the signal will not be detected and the
lawnmower will stop.
Acute angle Right angle or
obtuse angle
The boundary wire must not be laid with any
acute angles.