Honda 85RB EXPERT 2006, Руководство пользователя

Страница: 81 / 134

Adjustments for Competition
77
Front Suspension Adjustments
28.Align the groove (23) in the fork tube (10)
with the top surface of the upper fork clamps
(24).
29.Temporarily tighten the fork lower pinch bolts
(7) and then tighten the fork cap (2) to the
specified torque:
25 lbf·ft (34 N·m, 3.5 kgf·m)
30.For ease of releasing air pressure after the
forks are installed, loosen the lower pinch
bolts and position the fork outer tubes so that
the pressure release screws are in front of the
rebound damping adjusters.
31.Tighten the fork lower pinch bolts to the
specified torque:
16 lbf·ft (22 N·m, 2.2 kgf·m)
32.Tighten the fork upper pinch bolts (1) to the
specified torque:
16 lbf·ft (22 N·m, 2.2 kgf·m)
Over-tightening the pinch bolts can deform the
fork tubes. Deformed fork tubes must be
replaced.
(1) upper pinch bolts (10) fork tube
(2) fork cap (23) groove
(7) lower pinch bolts (24) upper fork clamp
33.Clean the threads of the fork protector bolts
and axle holder thoroughly.
34.Apply locking agent to the bolt threads.
35.Install the fork protectors (5) and tighten the
bolts to the specified torque:
5.2 lbf·ft (7 N·m, 0.7 kgf·m)
(5) fork protectors
36.Clean the surfaces where the front axle shaft
and axle clamps contact each other.
37.Install the left and right side collars into the
wheel hub.
38.Insert the front axle shaft through the wheel
hub from the right side. Make sure the axle
shaft is seated firmly onto the left fork leg
clamp inner surface.
39.Tighten the axle nut (3) to the specified
torque:
46 lbf·ft (62 N·m, 6.3 kgf·m)
(3) axle nut
40.Align the brake caliper (6) and hose with the
left fork leg, making sure that the brake hose
is not twisted. An improperly routed brake
hose may rupture and cause a loss of braking
efficiency.
41.Clean the threads of the caliper mounting
bolts (25) and brake caliper thoroughly.
42.Apply locking agent to the bolt threads.
43.Install the brake caliper on the fork slider and
tighten the caliper bolts to the specified
torque:
22 lbf·ft (30 N·m, 3.1 kgf·m)
Fit the brake caliper over the disc, taking care
not to damage the brake pads.
(6) caliper (25) caliper mounting bolts
NOTICE
NOTICE
(7)
(23)
(5)
(3)
(2)
(10)
(1)
(24)
(25)
(6)
(cont’d)
CR85R/071-079 05.6.8 2:26 PM ページ 77