2. Remove the electrical connector
from the bulb by pulling the
connector straight back.
3. Remove the rubber weather seal
by pulling on the tab.
4. Unclip the end of the hold-down
wire from its slot. Pivot the wire
out of the way, then remove the
bulb.
5. Install the new bulb into the hole,
making sure the tabs are in their
slots. Pivot the hold-down wire
back in place, and clip the end into
the slot.
6. Install the rubber seal over the
back of the headlight assembly.
Make sure one of the three arrows
on the rubber seal is facing up; it is
marked
‘‘ ’’
.
7. Push the electrical connector onto
the new bulb. Make sure it is
connected securely. Turn on the
headlights to test the new bulb.
8. (Driver's side)
Install the front end of the air
intake duct.
Replacing a Daytime Running
Light Bulb
1. Open the hood.
2. Remove the electrical connector
from the bulb by pushing on the
tab and pulling the connector
down.
3. Remove the bulb by turning it one-
quarter turn counterclockwise.
TAB
Lights
262