−
−
−
＋
−
The ignition switch must be in the
ACCESSORY (I) or ON (II) position.
Turn the system on by pressing the
PWR/VOL knob, or the AM or FM
button. Adjust the volume by turning
the knob.
The band and frequency that the
radio was last tuned to is displayed.
To change bands, press the AM or
FM button. On the FM band, ST will
be displayed if the station is broad-
casting in stereo. Stereo
reproduction on AM is not available.
You can use these five methods to
find radio stations on a selected
band:
the
preset buttons, and
.
Use the TUNE knob to
tune the radio to a desired frequency.
Turn the knob right to tune to a
higher frequency, or left to tune to a
lower frequency.
The SEEK function
searches up and down from the
current frequency to find a station
with a strong signal. To activate it,
press the
or
side of the
bar or (
)/(
) buttons, then
release it.
The SCAN function
samples all the stations with strong
signals on the selected band. To
activate it, press the SCAN button,
then release it. You will see SCAN in
the display. The system will scan for
a station with a strong signal. When
it finds one, it will stop and play that
station for about 5 seconds. If you do
nothing, the system will then scan
for the next strong station and play it
for 5 seconds. When it plays a station
that you want to listen to, press the
SCAN button again.
CONTINUED
Playing the Radio
To Play the Radio
To Select a Station
TUNE, SEEK, SCAN,
AUTO SELECT
TUNE
SEEK
SCAN
Fe
a
tu
re
s
93
