Disconnect the wire connector
from the ignition coil by pushing
on the lock tab and pulling on the
connector. Pull on the plastic
connector, not the wires.
Remove the spark plug with
a five-eighths inch (16 mm) spark
plug socket.
Use a wrench to remove the
hexagon socket head cap bolt
holding the ignition coil. Remove
the ignition coil by pulling it
straight out.
Loosen the two holding clips by
turning the heads one-quarter turn
counterclockwise with a flat-tipped
screwdriver. Remove the cover on
the front cylinder bank by pulling
it straight up.
Clean off any dirt and oil that has
collected around the ignition coil.
1.
2.
3.
4.
5.
Replacement
Spark Plugs (6-cylinder Models)
Maintenance
292
HOLDING CLIP
CONNECTOR
HEXAGON SOCKET HEAD CAP BOLT
IGNITION COIL