© 2014 American Honda Motor Co., Inc. – All Rights Reserved.
AII 00273 (1410)
3 of 35
INSTALLATION
Customer Information: The information in this
installation instruction is intended for use only by skilled
technicians who have the proper tools, equipment, and
training to correctly and safely add equipment to your
vehicle. These procedures should not be attempted by
“do-it-yourselfers.”
NOTE: This antenna should be installed only if the
ambient air temperature 15°C (60°F) or above.
1.
Move the driver’s seat all the way back.
2.
Disconnect the negative cable from the battery.
3.
Attach the ID label.
•
Using isopropyl alcohol on a shop towel, clean
the area where the ID label will attach.
•
Attach the ID label to the transmitter in the area
as shown.
With Driving Position Memory System
NOTE: The remote is factory set for driver 1 remote
control. To program the driver 2 remote, follow the
“Register New Transmitter” instructions on ISIS.
QB20939DH
ID LABEL
TRANSMITTER
Clean with
isopropyl
alcohol.
Without Driving Position Memory System
QB32111CH
ID LABEL
TRANSMITTER
Clean with
isopropyl
alcohol.
Removing the Vehicle Parts
4.
Remove the roof console.
•
Using a plastic trim tool, pry out and remove the
left and right lens.
•
Open the sunglass holder and remove the four
screws.
•
Remove the roof console and unplug the vehicle
connectors.
Q0N2012AG
VEHICLE
CONNECTORS
ROOF
CONSOLE
4 SCREWS
4 RETAINING
TABS
LEFT
LENS
SUNGLASS
HOLDER
(Open.)
4 RETAINING
TABS
RIGHT
LENS
