12 of 22
AII 27573 (0410)
© 2004 American Honda Motor Co., Inc - All Rights Reserved.
3605060M
MODULATOR
BRACKET
HALF
CUSHION
TAPE
CUSHION TAPE
Cut
5 mm
FLANGE
NUT
PLAYER
BASE-
BRACKET
5 x 10 mm
WASHER-
SCREW
HALF
CUSHION TAPE
Clean with
isopropyl
alcohol.
3605071M
4 x 8 mm
WASHER-
SCREW
PLAYER BASE
BRACKET
MODULATOR
BRACKET
4 x 8 mm
WASHER-
SCREW
FM MODULATOR
BRACKET
HOLE OF THE
MODULATOR
BRACKET
CONNECTOR CLIP
30. Inside the center console, locate the welded nut
on the vehicle stay. Attach the XM radio harness
ground terminal to the welded nut with the ground
bolt supplied.
31. Secure the XM radio harness to the vehicle
harness with one wire tie. Route the 3-pin
connector, and the remaining end of the XM radio
harness toward the rear of the vehicle; they will be
routed later.
FM Modulator Unit Installation
32. To protect the center panel, attach masking tape
to the center panel in the area shown.
33. Attach the modulator bracket to the player base-
bracket with two 5 x 10 mm washers and two
5 mm flange nuts.
34. Using scissors, cut one cushion tape in half.
Using isopropyl alcohol, clean the bonding
surfaces of the brackets, and attach the half
cushion tapes to the brackets in the area shown.
35. Install the FM modulator unit to the modulator
bracket with two 4 x 8 mm washer-screws. Attach
the connector clip from the FM modular unit
harness into the hole in the player base-bracket.
3606010M
GROUND
BOLT
GROUND
TERMINAL
XM RADIO
HARNESS
VEHICLE
HARNESS
WIRE TIE
3-PIN
CONNECTOR
2506010T
MASKING
TAPE
CENTER
PANEL