Honda 08A53-S2A-101, Руководство по установке

Страница: 8 / 8

8 of 8
AII 38245 (0710)
©
2007 American Honda Motor Co., Inc. - All Rights Reserved.
3626030M
VEHICLE
SUBHARNESS
ANTENNA
CABLE
VEHICLE
SUBHARNESS
ANTENNA
CABLE
WIRE TIE
WITH CLIP
2 SLITS
2 XM RADIO
UNIT BOLTS
XM RADIO
BRACKET
29. Push the clip of the other wire tie with clip into the
XM radio bracket hole.
30. Attach the EPT sealer to the XM radio unit corner
edge where the antenna cable and vehicle harness
will contact. Place half the EPT sealer on the top
surface and half on the side.
31. Plug the antenna cable and vehicle subharness
connector into the XM radio unit.
32. Loosen the two XM radio unit bolts, and insert
their threads into the slits in the XM radio unit
bracket.
3613011M
WIRE TIE
WITH CLIP
ANTENNA
CABLE
VEHICLE
SUBHARNESS
XM RADIO
BRACKET
XM RADIO UNIT
EPT SEALER
RADIO BRACKET
HOLE
35. Secure the antenna cable to the vehicle harness
with one wire tie, as shown.
36. Loop the antenna cable, and secure it to the
vehicle harness with two wire ties.
37. Check that all wire harnesses and cables are
routed properly and that all connectors are plugged
in. Open and close the trunk lid several times, and
visually check that the antenna cable has not
been pinched around the trunk hinge arm.
38. Reinstall all removed parts. Check that all clips
and all other fasteners are installed securely.
39. Reconnect the negative cable to the battery.
40. Enter the customer’s radio anti-theft code, and
reset the radio station presets.
41. Reset the clock.
42. Activate the XM Satellite Radio demo service, and
then check the operation of the XM radio system
according to the vehicle owner’s manual.
3613021M
WIRE TIE
(step 35)
VEHICLE
HARNESS
WIRE TIE ANTENNA
CABLE (Loop.)
33. Tighten the two XM radio unit bolts securely.
34. Attach the wire tie with clip installed in step 29 to
the antenna cable and the vehicle subharness.