4 of 8
AII 38245 (0710)
©
2007 American Honda Motor Co., Inc. - All Rights Reserved.
10. Position the XM radio bracket on the insulator,
and align the four holes in the bracket with the four
welded nuts in the fuel tank. Install two 6 x 10 mm
washer-bolts to the bracket, and temporarily
tighten them. Install two 6 x 10 mm washer-bolts
to the rear of the bracket, and temporarily tighten
them. Tighten the front two bolts securely, then
tighten the rear two bolts.
Installing the XM Radio Antenna
11. Using scissors, cut out the template, and fold the
three tabs along the dotted lines.
12. Position the template on the back of the trunk lid.
Use masking tape to secure the template while
aligning the dotted lines on the template with the
edges of the panel in the trunk lid.
13. Lightly center-punch the template as marked, then
remove the template.
3612031M
FUEL TANK
4 WELDED
NUTS
INSULATOR
6 x 10 mm
WASHER-
BOLTS (4)
XM RADIO
BRACKET
BOLT
BOLT
3612081M
Discard.
TAB
Fold tabs
along the
dotted lines
(3).
Cut the outline
of the template.
3612090M
TRUNK LID
MASKING
TAPE
TEMPLATE
LID PANEL EDGE
AND DOTTED LINE
2 MARKS
CENTER PUNCH
• Using a utility knife, cut the square out of the
insulator, then locate the welded nut. Remove
the insulator adhesive tape from around the nut
threads, and thoroughly clean the area. Do not
drop debris into the nut.
3612021M
INSULATOR
3 SQUARES
UTILITY
KNIFE
INSULATOR
ADHESIVE TAPE
(Remove.)
