6 of 8
AII 38245 (0710)
©
2007 American Honda Motor Co., Inc. - All Rights Reserved.
23. Route the antenna cable through the trunk lid
panel holes in the areas shown.
24. Get one wire tie with clip from the kit. Push the
clip of the wire tie into the trunk lid panel clip hole,
and secure the antenna cable to the panel with the
wire tie.
25. Secure the antenna cable to the vehicle harness
at the front of the trunk lid panel hole and inside
the hole with two wire ties.
26. Route the antenna cable along the vehicle harness
at the trunk lid hinge arm, and secure it to the
vehicle harness with three wire ties in the areas
shown.
19. Install the two corrugated tubes onto the antenna
cable using vinyl tape in the areas shown.
3612141M
WIRE TIE
WIRE
TIE
WIRE TIE
TRUNK LID
HINGE ARM
ANTENNA
CABLE
CORRUGATED
TUBE
(Vinyl Tape)
830 mm
30 mm
EPT SEALER
ANTENNA
CABLE
EPT
SEALER
(step 22)
5 mm
(Wrap over.)
VINYL
TAPE
(step 20)
EPT
SEALER
3612131M
Align the EPT
sealer with the
hole edge.
WIRE TIE
HOLE
HOLE
WIRE TIE
WITH CLIP
PIECE OF WIRE
(if necessary)
ANTENNA
CABLE
WIRE TIE
VEHICLE
HARNESS
CORRUGATED
TUBE
(Vinyl Tape)
21. Wrap vinyl tape around the end of the corrugated
tube and the EPT sealer at the trunk lid panel.
22. Wrap one EPT sealer around the end of the other
corrugated tube, as shown.
20. Wrap two EPT sealers around the antenna cable
between the corrugated tubes, as shown.
EPT
SEALER
(step 19)
