HONDA marine BF115J, Руководство пользователя

Страница: 81 / 170

80
STARTING THE ENGINE
3. Turn the ignition switch key to the
START position until the engine
starts.
When the engine starts, release the
key, allowing it to return to the ON
position.
• The starter motor consumes a
large amount of current. Do not
therefore run it continuously for
more than 5 seconds at a time. If
the engine does not start within 5
seconds, wait at least 10 seconds
before running the starter motor
again.
• Do not turn the ignition switch
key to the START position while
the engine is running.
• When the boat is mounted with the
two outboard motors, perform the
above procedure on the right and
left outboard motors respectively.
• The “Neutral Starting System”
prevents the engine from being
started unless the control lever is
set in the N (neutral) position even
though the engine is cranked by the
starting engine.
4. After starting, check whether the
cooling water is flowing out of the
cooling water check hole. Amount
of water flowing out of the check
hole might vary due to the
thermostat operation, but this is
normal.
START
ON
START
IGNITION
SWITCH KEY
ON
COOLING WATER
CHECK HOLE
COOLING WATER
INTAKE PORT (each side)
32ZVT600.book 80 ページ ２０２１年１０月１５日 金曜日 午後４時９分