PRODUCT INSTALLATION
Power supply
Turn on the valve
1.Install the 120V (greater than 15A) socket at a
position above 23.5"(60cm) from the ground.
2.The socket should be installed in a place
where water is not easy to splash.
3.Use a grounded socket.
4.Insert the leakage protection
plug of the product into
the socket.
WARNING
Please connect the power according to the
power supply requirements of the product,
otherwise it may cause product failure;
the plug should be connected to an
effectively grounded socket,
Otherwise, in the case of power failure or
leakage,
it may cause electric shock.
Before turning on the power, valve must be turned on for water supply to the unit.
Valve
CAUTION
When power is turned on,unit self-check system will be activated.
You will hear an alarm under water supply failure. The following steps should be taken then:
Turn off the power-- turn on the valve---power on again.
Power and water supply
Installation diagram
Water supply
Waterproof 10A socket with
ground fault circuit breaker
The installation location of water
and electricity should be set
separately
Wall
T-valve
Valve
T-valve
It is recommended to
be larger than 23.5"(60cm)
The water supply source is transferred through the T-valve, one end is connected to the
ceramic water tank to enter the water,the other end is connected to the water supply hose ,
and finally the water supply hose outlet is connected to the adapter of the unit.
1. Applicable water pressure range is
10.87~108.7psi(0.075MPa-0.75MPa)
;
2. Applicable water temperature range
is 41-95
℉
(5~35
℃
)
;
3. Water supply hose length 23.5"(60cm);
Valve should be close to the installation
and disassembly position of this product.
4. Use the new hose set included with this
equipment.
Do not reuse an old hose set.
Main unit
Adapters
Connect to water tank
Connect main unit
WARNING
Valve (shut-off/turn-on)
USER MANUAL
Homtone
USER MANUAL
Homtone