Wiring Diagram
HR-REP-120
(Side View)
1.
Find a suitable location for the Hybrid Repeater.
Place the repeater in a convenient and accessible
location.
Note:
Hybrid Repeaters must be within 60
feet (18 m) of an RF Processor or another repeater
when using the RF Link for repeater-to-repeater or
repeater-to-processor communication.
2.
Connect Hybrid Repeater Link (if applicable).
Connect the Hybrid Repeater Link communication
wires from the HomeWorks
®
Processor (or previous
Hybrid Repeater in the daisy chain) to the terminal
block on the Hybrid Repeater (see Wiring
Diagram). Each terminal will accept up to three
22-18 AWG (0.5-1.0 mm
2
) wires.
Note:
If using the plug-in adapter to power the
repeater,
DO NOT
connect the +15 V terminal
(terminal 2).
3.
Apply power to the Hybrid Repeater.
If the
Hybrid Repeater is to be powered by the Hybrid
Repeater Link, apply power by turning on the
HomeWorks
Processor. If the Hybrid Repeater is to
be powered by the plug-in adapter, insert the
adapter cord plug into the jack on the Hybrid
Repeater, then plug the adpater into a standard
wall receptacle.
2
English
Français
Esp
añol
Português
Installation
Wall Mounting
Hybrid Repeaters may be wall mounted using the
supplied wall bracket.
STATUS and
TEST LEDs will
be dimly lit when
first powered
Plug in
power cord
and adapter
Plug in
adapter jack
1.
Attach wall bracket to wall using the supplied
screws and wall anchors.
2.
Place power cord into notches at top and bottom of
wall bracket. Wrap excess power cord around the
cord holder. Route Hybrid Repeater Link wiring
through hole in wall bracket and out through side
cutout. Align repeater and snap onto wall bracket.
UP
UP
MUX
MUX
+15 V
COM
Power Cord
Hybrid
Repeater Link
Wiring
RF TX/RX LEDs
Indicate RF Link
activity.
STATUS LED
Indicates the status of the
HomeWorks
system.
Note: When the Hybrid Repeater is
powered, but has not yet been assigned
an address from the HomeWorks
Illumination Software, the STATUS and
TEST LEDs will be dimly illuminated.
Operation
TEST LED
A slow flash indicates
RF communications
tests are in progress
STATUS Button
Used when addressing the
Hybrid Repeater from the
HomeWorks
Illumination
TM
Software.
TEST Button
Activates RF communication
tests. To activate the tests,
press and hold the TEST
Button until the TEST LED
begins to flash.
Note:
For communication tests,
the Hybrid Repeater,
HomeWorks
Processor, and
other RF devices must first be
configured and addressed
using the HomeWorks
Illumination
Software.
WIRED TX/RX LEDs
Indicate Wired Link
activity.
