4
Homewerks.com
Pre-Installation
PLANNING INSTALLATION
Before beginning assembly of the product, make sure all parts are present. Compare parts with the package contents list and hardware
contents. If any part is missing or damaged, do not attempt to assemble, install, or operate the product. Contact customer service for
replacement parts.
NOTE:
Keep your receipt and these instructions for proof of purchase.
□
Check area above installation location to be sure that wiring can run to the planned location and that duct work can be run and
the area is sufficient for proper ventilation.
□
Inspect duct work and wiring before proceeding with installation.
□
Before installation, provide inspection and future maintenance access at a location that will not interfere with installation work.
□
You may need the help of a second person to install this fan; one person on the attic side and one on the room side.
NOTE:
Installation may vary depending on how the previous bath fan was installed. Supplies necessary for the installation of your bath
fan are not all included. However, most are available at your local home improvement or hardware store.
Wiring Diagram
WARNING:
Wiring must comply with all
applicable electrical codes. Turn off power
before removing or installing connectors.
WARNING:
COPPER TO COPPER ONLY. Do not use
aluminum wire.
CAUTION:
Accessory part (quick connector)
should meet installation instructions below.
NOTE:
The connector is reusable on solid wires of
the same wire gauge or smaller. Do not reuse the
connector on stranded wires.
□
Strip wires 3/8 in. - 1/2 in.
□
Grip the wire firmly and push the stripped end of
the wire into the open port of the connector. Use
only one conductor per port.
□
Verify the stripped end of the wires is fully inserted
to the back of the connector.
CAUTION:
Wiring maximum temperature rating 221˚F (105˚C). 600V maximum for building wiring and 1,000V maximum for signs and light
fixtures. The acceptable wire range is 18-16 AWG Sol. Cu.
Capacitor
For Long
Life of
Motor
Automatic Terminal Switch
Motor
Fan Housing
Electrical
Box
Humidity
Sensor
To 120V / 60 Hz
Black Wire
White Wire
To Switch
To Neutral
Green Wire To Ground
Quick Connector
Product Wires
House
Wires
