2
PRODUCT SPECIFICATIONS
SPECIFICATIONS
SPECIFICATIONS
Max. flow rate: 2.2 GPM (8.5 LPM) at 60 PSI
Brass waterways
ASME A112.18.1/CSA B125
Manufactured to include no more than 0.25% weighted
average lead content on wetted surfaces
NSF 61-9
Ceramic cartridge
Total weight of item: 1.056 lbs.
www.homewerksww.com
ASSEMBLY INSTRUCTIONS
1. Turn off water at the supply
valve under the sink or at the
main water supply, disconnect
the supply line, and remove old
faucet.
Clean and dry surface area
where new faucet will be
mounted.
1
5. Reconnect the water supply
line.
If using a flexible braided
supply line (5.1) (not included),
connect the end with 1/2"
female IPS to the faucet tail-
piece. Hand tighten, snug tight
with a 1/4" turn using a wrench
(do not overtighten). Install the
other end to your shut off valve
or supply tube.
If using a ball-tip supply line
(5.2) (not included), slip the
supplied coupling nut (EE)
behind the ball-tip. Insert the
ball-tip into the faucet tailpiece.
Tighten coupling nut with
wrench (do not overtighten).
5
5.1
5.2
EE
2. Cover tailpiece of faucet with
PTFE pipe tape (wrapped clock-
wise) or pipe joint compound.
2
3. Place rubber washer (AA) over
shank of faucet.
Place tailpiece through hole in
counter top or fixture.
AA
3
6. Attach supply tube to shut-off
valve. Do not overtighten.
Turn water supply or shut-off
valve back on and check for
leaks.
6
4. From under the sink, put the
metal washer (BB) over the
tailpiece. Thread the mounting
nut (CC) onto the tailpiece and
hand tighten. Use a wrench to
tighten the mounting nut (do not
overtighten).
4
BB
CC
7. Install handle (B) with Phillips
screw driver (not included).
Cover screw (EE) with either
“H” or “C” index button (C).
C
7
C
B
EE
