VELOCITY WAXER
™
P/N C800669
6
OPERATING INSTRUCTIONS
APPLICATION OF WAX CONTINUED
5. Open the plug on the NOZZLE WITH PLUG before using.
6. Place an application bonnet on the PAD.
7. Place one hand on the HOUSING and the other hand on the
WAX-FEEDING MOTOR SWITCH.
8. Start the WAX FEEDING MOTOR SWITCH to apply the appro-
priate amount of wax on the car.
Note:
Use a conservative amount of wax.
9. Start the PAD MOTOR SWITCH. The rotating pad will spread
the liquid wax evenly on the car body. Repeat until all the
surface of the car is covered with a thin layer of wax. The
WAX-FEEDING MOTOR SWITCH and PAD MOTOR SWITCH
are controlled by independent switches; the WAX-FEEDING
MOTOR SWITCH and PAD MOTOR SWITCH can be executed
at the same time.
Note:
The polisher should always be started on or against
the surface of the car.
10. Apply wax by hand to all hard-to reach surfaces,
for example, under the bumpers, around the door
handles, etc.
POLISHING
1. Cover the NOZZLE WITH PLUG after waxing to prevent the
spillage of wax.
2. Remove applicator bonnet from the PAD. Replace with wax
removal bonnet.
3. Start the PAD MOTOR SWITCH; polish the wax from front to
back using long strokes.
4. Remove the wax in the same order as it was applied.
5. DO NOT press down. Let the polisher do the work. If the
wax seems difficult to polish, you may have applied too
much wax.
CLEAN UP
1. Open the WAX FEEDING COVER and remove the plug and
empty the remaining wax into a bucket.
2. Add water to WAX FEEDING FUNNEL, press the WAX
FEEDING MOTOR SWITCH to spray the water until the WAX
RESERVOIR and NOZZLE WITH PLUG until clean. Insert the
plug and close the WAX FEEDING COVER until next use.
Note:
For best results us a light detergent soap, flush until
clean.
3. Squeeze the latch button on each side of the battery pack
and pull the battery out of the polisher and store battery.
Wax 5
Wax 8
Wax 9
Wax 6
Polish 3
Clean Up 1
Clean Up 2
Clean Up 2
