OPERATION WARNINGS/INSTRUCTIONS
There must be a bonnet on the polishing pad before using the polisher.
Do not press down on the polisher, the machine’s actions, not pressure does the best job.
The polisher cannot be upside down or at a serious incline for the wax to be sprayed.
Polish from the front to back of the car.
The wax in the reservoir shall not be less than 50 mL (1.5 oz) or the wax cannot be sprayed.
Do not make adjustments to the polisher while it is in operation.
When the polisher is not in use for a short duration, rest the polisher in the position shown
in Figure A.
• Before you begin, make sure the work surface is clean and dry. If the work surface is a car,
remove road tar with a general cleaner and remove excess grease spots, bugs, stains, and
other surface problems before waxing or polishing.
• Make sure the work surface is free of objects that could tear the bonnet or damage the pad.
• Make sure a clean bonnet is used at the start of each project.
• Always start and stop polisher on or against the surface of the car.
• The most common error is applying too much wax.
• If the bonnet should come off the pad, you may be using too much wax.
• Do not wax a surface in direct sunlight.
• Do not leave wax on a car or work surface for an extended time period.
• Follow the recommendations provided with the wax to avoid wax removal problems and/or paint damage.
APPLICATION OF WAX
1. Insert the BATTERY PACK into the polisher. Align the polar-
ity rib on the BATTERY PACK with the polarity slot in the
polisher handle and slide the pack into the polisher. Make
sure the latches on the BATTERY PACK have snapped into
place.
2. Check the BATTERY PACK alignment by lightly pulling on
the end of battery pack.
3. Press the WAX FEEDING COVER to open and remove the
plug in the WAX-FEEDING FUNNEL.
4. Add liquid wax up to 150 mL (5 oz) scale in the WAX
RESERVOIR (no more than 150 mL), attach the plug and
close the WAX FEEDING COVER.
Note:
Check the sealing of the plug to avoid the spillage
of the wax. Be careful not to spill the wax on the housing
when adding the wax.
OPERATING INSTRUCTIONS
Wax 1
Wax 3
Wax 4
Wax 4
Wax 3
Wax 2
Figure A
VELOCITY WAXER
™
P/N C800669
5
