Setting the Limits
The Travel Limits regulate the points at which the
door will stop when moving UP or DOWN. During the
SetUp procedure, the motor will run and operate the
door. The Opener must be fully installed on the door
and all installation steps completed before
proceeding.
Make sure the door is clear of obstruction.
Ensure your hands are away from any
moving parts before activating the door.
Position the door about half way and Engage the
motor. (Section 10 page 7).
Remove the Lens cover from the Opener.
Connect the Opener to a 240VAC Power Point and
Turn On.
SET TOP LIMIT
• Press and Hold the
Black
Limit button until the
orange indicator Led starts flashing slowly, and then
release. (Courtesy LEDs will go to low illumination).
• Press and Hold the
Black
Limit button, until the
door reaches the desired open position. If set too
high, adjust down using the
Purple
Learn button.
(Make sure there is enough room for your vehicle to
pass under).
SET BOTTOM LIMIT
• Press and Release the
Green
Start button, this sets
the UP limit and begins
closing
the door, once the
opener starts to move down,
IMMEDIATELY
Press
and Hold the
Purple
Learn button until the door
reaches the desired closed position, then release
button or momentary press to inch further.
SAVE AND TEST
• Press and Release the
Green
Start button, this sets
the DOWN position and begins
opening
the door to
the fully open position.
• Close and Open the door 3 or 4 times using the
Green
Start button to confirm the limit settings.
Courtesy LEDs should now be fully illuminated.
Repeat the above procedure if necessary.
The Force Must now be set in order to
complete your installation, see step 13.
12
Ensure Motor is Engaged
8
Содержание HE60R
Страница 2: ...0 ...
