HomeMatic HMIP-eTRV-2, Инструкция по установке и эксплуатации

Страница: 38 / 153

38
Start-up
with magnet) for at least 4 seconds to activate the pairing
mode. The device LED starts to flash orange
(see figure 4) . For
further information, please refer to the operating manual of the
corresponding device.
The device LED lights up green to indicate that adding has been successful.
If adding failed, the device LED lights up red. Please try again.
If no pairing operations are carried out, pairing mode is exited
automatically after 3 seconds.
If you want to add another device to the existing devices, first activate
the pairing mode of the existing device and afterwards the pairing
mode of the new device.
If, for example, you want to add another radiator thermostat, first
pair the new radiator thermostat to the existing radiator thermostat.
Afterwards, you can pair the new radiator thermostat with the
existing window / door contact.
If you are using several devices in one room, you should pair all
devices with each other.
5.1.2 Adding to the Access Point (alternative)
If you have already connected the device to another Homematic IP
device, you first have to restore the factory settings of the device
before you can connect it to the Homematic IP Access Point or
another Central Control Unit CCU3 (see see „1 Information about this
manual“ on page 34).
First set up your Homematic IP Access Point via the Homematic IP
app to enable operation of other Homematic IP devices within your
system. For further information, please refer to the operating manual
of the Access Point.
You can connect the device either to the Access Point or to the
Homematic Central Control Unit CCU3. For detailed information,