50
Start-up
•
The wireless remote control will now be in confi
-
guration mode. The device LED will flash green to
indicate this. (To exit configuration mode, briefly
press the teach-in button again.)
• To enter teach-in mode, press the wireless remote
control control button in to which you wish to teach
a function. The device LED will flash orange slowly.
(Provided the device to be taught in is not yet in
teach-in mode, you can cancel teach-in mode on
the wireless remote control by pressing the teach-
in button again briefly. The device LED will then
light up red.)
• Now put the device in to which you wish to teach
the wireless remote control into teach-in mode by
following the relevant operating manual instruc-
tions.
• If both devices are in teach-in mode, the LED will
flash orange quickly to indicate this.
When the teach-in process is complete, the LED will
light up green for 1 second to indicate that the process
has been successful.
If the device LED lights up red for 2 seconds, this in-
dicates that the teach-in process was not successful.
You must carry out the process again if this happens.
