48
49
Start-up
Start-up
To teach-in your device to the central control unit,
proceed as follows:
•
Open the “WebUI” user interface in your browser.
•
Click the “Teach-in devices” button on the right-hand
side of the screen.
•
To activate teach-in mode, click “Start teach-in
mode”.
•
Teach-in mode remains activated for 60 seconds.
An information box shows how much teach-in time
remains.
•
Meanwhile, please activate the teach-in mode of
your switch actuator to teach-in as well. Connect
a suitable voltage-stable push button to the push
button input (see sec. “5 Installation” on page
40) and push and hold down the button for at
least 4 seconds, until the device LED will light up
permanently.
After a short time, the newly taught-in device will
appear in the inbox of your software interface. The
button “Inbox (x new devices)” indicates how many
new devices have been taught-in successfully.
If required, you can teach-in additional devices by
repeating the steps described above for each device.
Now configure the newly taught-in devices in the inbox
as described in the next section.