38
Start-up
the connection pins into the appropriate bracket
of the mounting plate (see
figure 5
).
• Switch the Homematic IP Wired bus on again to
activate the teach-in mode of the device (see “5.4
Teaching-in” on page 38).
5.3
Installation into other frames
You can mount the device with the frame
(B)
provided or
use it with frames of other manufacturers. The electronic
unit
(C)
can also be integrated into a multi-gang frame
(see
figure 6
). For mounting with multi-gang frames,
make sure that the mounting plate of the device is
seamlessly aligned to the already fixed mounting plate/
retaining ring.
An overview of compatible switch series is available in the
download area of www.homematic-ip.com.
5.4
Teaching-in
Read this entire section before starting the
teach-in procedure.
Please refer to the Homematic IP Wired System
Manual for detailed information on setup and
control options.
To integrate the device into your system and enable it to
communicate with other devices, you must teach it in first.
You can use the following set-up and control options:
Содержание HmIPW-WRC2
Страница 3: ...2 1 A B E F D C 1 2 ...
Страница 4: ...4 3 2 1 ...
Страница 5: ...click 6 5 click ...
Страница 7: ...10 9 4 s 4 s ...
