38
Start-up
5.2
Installation
The bus is powered by the Homematic IP Wired
Access Point (HmIPW-DRAP). For further
information, please refer to the operating manual
of the corresponding Wired Access Points.
To facilitate connection to the terminals, the
green push-in terminal
(B)
can be removed from
the device. Therefore, press the push-in terminal
with a pointed object from the bracket (e.g. with
a small screw driver) (see
figure 2
).
For the installation, please proceed as follows:
• Disconnect the corresponding line of the
incoming Homematic IP Wired bus.
• Connect the Homematic IP Wired bus to the
bus connecting terminals
(C)
(see
figure 3
). To
connect and loosen the single wires, press the
orange clamp using a small screwdriver.
• Place the device on the flush-mounted box and
fasten it to the flush-mounted box using the
screws supplied (see
figure 4
).
• Place the frame of your existing switch series on
the device (see
figure 5
). You can also integrate
the device into multi-gang frames (
see figure 6
).
• Place the rocker of your existing switch series
including the corresponding adapter (see “5.3
Adapters for brand switch systems” on page
Содержание HmIPW-BRC2
