52
Start-up
After a successful adaptation run, each heating
zone is shown in the display according to the val-
ve position.
6.4
Teaching-in
Please read this entire section before starting
the teach-in procedure.
To integrate the floor heating actuator into your system
and enable it to communicate with other devices, you
must teach it in first.
You can either pair the floor heating actuator directly with
other Homematic IP devices (e.g. the wall thermostat or
the Multi IO Box) or teach it in to the Homematic IP Ac-
cess Point. After pairing, the device is configured at the
wall thermostat. After teaching-in to the Access Point, the
device is configured via the Homematic IP app.
6.4.1
Pairing with a Homematic IP Wall Thermostat
Please make sure you maintain a distance of at
least 50 cm between the devices.
You can cancel the pairing procedure by briefly
pressing the system button
(A)
again. This will be
indicated by the device LED
(A)
lighting red.
If no pairing operations are carried out, pairing
mode is exited automatically after 3 seconds.
Содержание HmIP-FALMOT-C12
Страница 3: ...1 A B G E D C F I H J 1 2 3 4 5 6 7 8 9 10 11 12 ...
Страница 4: ...2 3 120 mm K L N M ...
Страница 5: ...4 5 ...
Страница 6: ...6 7 Channeltaste drücken Selecttaste drücken press channel button press select button ...
