Homematic IP HmIP-BSM, Инструкция по установке и эксплуатации

Страница: 19 / 30

36 37
Hazard information Hazard information
Do not use the device if there are signs of dam-
age to the housing, control elements or connect-
ing sockets, for example. If you have any doubts,
have the device checked by an expert.
The device may only be operated in dry and dust-
free environment and must be protected from
the effects of moisture, vibrations, solar or other
methods of heat radiation, cold and mechanical
loads.
The device is not a toy; do not allow children to
play with it. Do not leave packaging material lying
around. Plastic films/bags, pieces of polystyrene,
etc. can be dangerous in the hands of a child.
We do not assume any liability for damage to
property or personal injury caused by improper
use or the failure to observe the hazard informa-
tion. In such cases, any claim under warranty is
extinguished! For consequential damages, we as-
sume no liability!
The device may only be used for fixed installa-
tions. The device must be securely attached with-
in a fixed installation.
The actuator is part of the building installation.
The relevant national standards and directives
must be taken into consideration during planning
and set-up. The device has been designed solely
for operation on a 230 V / 50 Hz AC supply. Only
qualified electricians (to VDE 0100) are permitted
to carry out work on the 230 V mains. Applicable
accident prevention regulations must be com-
plied with whilst such work is being carried out.
To avoid electric shocks from the device, please
disconnect the mains voltage (trip the miniature
circuit-breaker). Noncompliance with the instal-
lation instructions can cause fire or introduce
other hazards.
When connecting to the device terminals, take
the permissible cables and cable cross sections
into account.
Loads connected to the relay outputs require suf-
ficient insulation.
Please take the technical data (in particular the
maximum permissible switching capacity of the
relay and the type of load to be connected) into
account before connecting a load! All load data
relates to ohmic loads. Do not exceed the capac-
ity specified for the actuator.