11
10
FCC Notice
Note -
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device
must accept any interference received, including interference
that may cause undesired operation.
Note -
This equipment has been tested and found to comply
with the limits for Class B digital devices, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the
receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
Note -
The manufacturer is not responsible for any radio or
TV interference caused by unauthorized modifications to this
equipment. Such modifications could void the user authority to
operate the equipment.
Troubleshooting
The UV will not activate
Please make sure the following steps have been taken:
• The valve is in the PURIFY position.
• The Adapter is plugged into a functional 3 pronged outlet.
• The Adapter cord is firmly seated in the pitcher base.
• The reservoir and lid must be installed and firmly seated.
• The Adapter battery is installed correctly. See adapter
battery door for instructions.
• Once the above steps have been taken, press and hold the
PURIFY button on the Adapter
The REPLACE FILTER indicator is blinking
In this condition the filter timer has expired indicating the filter
should be replaced.
• First follow steps to replace the filter in the Getting Started
section.
• To reset the timer, and turn off the blinking indication, hold the
button down for 5 seconds.
• The timer now begins the timing duration prescribed by the
programmed Cups per Day setting. See the User Interface
section for setting the Cups per Day.
