GB
| 8
GB
| 9
MEASURING OBJECT TEMPERATURE
1. Press the Power button to turn the thermometer on. All
symbols on the display will momentarily appear.
2. Ensure that the thermometer is in Object mode; the
Object symbol will be on the display. To alternate
between modes press and release the Human/Object
Mode button until you see the desired measurement
symbol on the display.
3. Press and hold the “Scan & measure button”, aiming
the Measurement Sensor at the object, holding the
thermometer approximately 0.5~3 cm.
4. Release the “Scan & measure button” and the
temperature reading will be displayed.
5. After about 30 seconds after use, the thermometer will automatically beep and
shut off.
MEMORY FUNCTION
You can recall up to 30 stored measurements in memory to share with your doctor or
trained healthcare professional.
Memory Recall button
.
1. When the device is on, press once briefly on the “MEM button”, then pass it again
to show the last measurement accompanied by
symbol.
2. The symbol or
symbol will appear with each measurement stored in
memory to indicate whether a person or object temperature was taken.
3. Each press of the same button recalls a previous measurement, so
then all
the way to
. Continue to press the
Memory Recall button
button to view the
next previously stored measurement.
4. Any new measurement will be recorded and the oldest memory deleted without
you having to do anything.
Memory Deletion
1. Under power on status, you may keep press MEM Button for more than 3 seconds
to delete all the readings.
2. You will see “--” on display and “sound four short beeps”, that mean all the
0.5~3 cm
0.5~3 cm
0.5~3 cm
0.5~3 cm
0.5~3 cm
0.5~3 cm
Содержание NO TOUCH
Страница 127: ......