5
SNOOZE/ LIGHT
1. Press the SNOOZE/ LIGHT button for an
extended backlight.
2. In snooze alarm mode, press this button to trigger
a repetitive snooze alarm.
3. When normal alarm mode is selected, press the button to
turn off alarm for one day.
MAX/MIN MEMORY SETTINGS
1. Press ”
MAX/ MIN
“ button to view the maximum values for
5 seconds. Press again to view the minimum values.
2. To clear the memory record, press “
CLEAR
” while the
respective values displaying on screen.
TEMPERATURE ALERT
Press “ALERT” to turn temperature alert on and off.
1. Hold “
ALERT
” button for 3 seconds to enter the alert
setting mode. The indoor icon will flash.
2. Press “
+
,
-
” to select the between indoor temperature or
remote sensor reading to be alerted to. Press “
ALERT
” to
confirm your selection. The Upper pointer and the value on
the LCD display will flash. Enter the desired upper limit
with the “
+
,
-
” buttons, press “
ALERT
” to confirm your
selection and then go to the lower limit setting.
3. Now the Lower pointer and value will be flashing. Enter the
desired lower limit with “
+
,
-
” buttons, then press
“
ALERT
” to confirm and exit.
4. You may enter an alert setting for the indoor temp and for
the remote sensor.
5. When temperature hits the limit of your preset levels,
the Upper/Lower pointers and the temperature of the
respective channel (indoor or remote sensor) will flash with
an audible alarm. Press any button on the home receiver
to acknowledge and stop the alarm.
SETTING CLOCK & CALENDAR
1. Hold “
SET
” button for 3 seconds until you hear a beep
to enter clock set.
2. First, select 12 hour or 24 hour setting using the “
+
,
-
”
buttons located on the back of the home receiver.
Press “
SET
” button to confirm your selection.
3.
Select Hour
- Use the “
+
,
-
” buttons located on the
back of the home receiver to adjust hour setting.
Press “
SET
” button to confirm your selection.
4.
Select Minute
- Use the “
+
,
-
” buttons located on the
back of the home receiver to adjust minute setting.
Press “
SET
” button to confirm your selection.
CENTIGRADE/FAHRENHEIT SELECTION
You can now select either Centigrade or Fahrenheit
temperature readings. Use the “
-
“ button located on the
back of the home receiver to select between Centigrade or
Fahrenheit readings.
SETTING ALARM TIME
1. Hold the “
CLEAR
” button for 3 seconds. Press “
+
,
-
“
to enter the desired Hr/ Min values and press “
CLEAR
”
to confirm setting.
2.
To view alarm time
- Press “
CLEAR
” button. Alarm time
will display for 5 seconds and then resume to normal
clock thereafter.
3.
To select between daily alarm and snooze alarm
-
Press “
+
“ button on the back of the unit.
4. The home receiver will provide either a daily alarm, which
last for 2 minutes or a snooze mode where the alarm will
repeat every 8 minutes until manually cleared
(see SNOOZE/LIGHT section below.)
4
