Replace the batteries if:
1. The low battery symbol appears on the display.
2. Nothing appears on the display when the power is switched on.
As the supplied batteries are for test only, they may be discharged earlier than
batteries you buy in stores. Replace the batteries in pairs. Remove batteries when
unit is not in use for extended periods of time.
NOTE: Batteries are hazardous waste. Do not dispose of them together with the
household garbage.
Battery
Cover
Installing Batteries
1. Press down on latch and lift the battery cover towards you to open the
battery compartment.
2. Install or replace 2 “AA” sized batteries in the battery compartment according to
the indications inside the compartment.
3. Replace the battery cover by clicking in the bottom hooks first, then push in the
top end of the battery door.
11
Inflation Symbol:
Appears when cuff requires inflation.
Deflation Symbol:
Appears when cuff is deflating.
Weak Battery Symbol:
Appears when batteries should be replaced.
Pulse Symbol:
Shows the pulse rate per minute.
Risk Category Indicator:
Compares readings against blood pressure
guidelines set by the JNC7 standard. See page 18 for more information.
If any of the following letters and numbers appear in the area that diastolic
pressure should be displayed, an error has occurred with your reading. See
Troubleshooting section of this manual for more information.
Measurement Error:
Measure again. Wrap the cuff
correctly and keep arm steady during measurement.
Air Circuit Abnormality:
Check cuff connection. Measure again.
Pressure Exceeding 300 mmHg:
Turn the unit off to clear, then
measure again.
Data Error:
Remove and reload the batteries.
Recalibration Alert:
Recalibration recommended.
See page 20 for information.
Display Symbols
10
