(888) 782-5618
1.
The solar panel should be cleaned periodically with a damp cloth to help maintain optimum performance.
2.
Do not use any cleaners with chemicals, solvents or harsh abrasives on this light. They could cause deterioration of the finish.
3.
If not to be used for several weeks, turn the unit OFF. Store it with the panel connected where the solar panel can receive sunlight.
4.
From time to time, ensure the plug between the solar panel and the light fixture is securely connected.
CLEANING AND MAINTENANCE
Solar Power Motion Activated Security Light
Model No. ES00726V
Use one 18650 Lithium-ion, 1500mAh, 3.7V rechargeable battery pack. For best
performance, replace with a new Lithium ion rechargeable battery pack every 18
months.
1.
Loosen the 4 lock screws (E), remove the back plate (D) from the light fixture
housing
(B).
2.
Disconnect the wire connection of the battery lead and remove the old
battery pack (C) from the battery compartment located inside the light fixture
housing (B). Replace with a new 18650 Lithium ion, 1500mAh, 3.7V
rechargeable battery pack.
3.
Replace the old battery with new battery making sure the polarity is correct.
4.
Replace the back plate (D) to the light fixture housing (B) with the 4 lock
screws
(E).
Battery replacement
RECHARGEABLE BATTERY
s e c u r i t y
www.homezonesecurity.com
* Slide the power switch on the front of light fixture housing to the AUTO position.
* Put the TIME switch at the bottom of the motion sensor in the TEST position.
* Put the DISTANCE switch in the position of your desired motion detection distance
(Low,Medium or High selection), it is always recommended to put it in H position for the
farthest motion detection distance.
Note: When the TIME switch is set to the “TEST” position, the light will operate during the
day or night. The light will stay on for 6 seconds after all motion is stopped.
Note: The motion sensor will need to completely warm up (about 15 seconds) before
beginning the setup process.
Figure 6: Testing the motion sensor
Note: Do not open, short circuit, or
mutilate battery as injury may occur.
* Keep the power switch in the AUTO position.
* Set the DISTANCE switch in the position of your desired motion detection distance (Low,
Medium or High selections).
* Put the TIME switch at the bottom of motion sensor in the position of your desired
duration (30 Seconds, 60 Seconds or 120 Seconds). The light will turn on at NIGHT
when motion is detected and turn off at the selected time interval after all motion stops.
Figure 7: Testing the motion sensor
Figure 6
Figure 7
