(888) 782-5618
HOW TO OPERATE AND INSTALL
OPERATION
Solar Power Motion Activated Security Light
Model No. ES00726V
s e c u r i t y
www.homezonesecurity.com
* Locate area in which you would like to install your light fixture.
* If mounting to a wood surface, drill one 3/32 in. hole into the mounting surface, install the
mounting screw (AA) through the center hole of the light fixture housing (B) and into the
mounting surface until fasten the light fixture on the wall.
* If mounting to a wall board or brick walls, drill one 7/32 in. hole into the wall surface.
Insert the wall anchor (BB), install the mounting screw (AA) through the center hole of
the light fixture housing (B) and into the fixed wall anchor (BB) until fasten the light fixture
on the wall.
Note: The light fixture should be mounted approximately 8-12 feet (2.4m-3.6m) above the
ground.
Figure 1: Mounting the light fixture
* If mounting to a wood surface, drill four 3/32 in. holes into the mounting surface. Using
the four mounting screws (AA) provided to secure the solar panel (A) to the mounting
surface.
* If mounting to a wall board or brick walls, drill four 7/32 in. holes into the wall surface and
insert the wall anchors (BB). Using the four mounting screws(AA) provided to secure the
solar panel(A) to the mounting surface.
* Adjust the angle of solar panel (A) so that it will receive maximum amount of direct
sunlight during the daylight hours.
Note: Ensure the light fixture and the solar panel are located for the cord to reach.
Note: For best result, locate solar panel to receive at least 3-4 hours direct sunlight daily.
Figure 2: Mounting the solar panel
Figure 1
Figure 2
Carefully route the wire from the solar panel (A) and plug it in the connector extending
from the bottom of the light fixture housing (B). Make sure the plug is securely connected.
Figure 3: Connecting the light fixture to the solar panel
* If needed, loosen the lock nuts, tilt the lamp heads up or down to adjust the light
coverage area, and then tighten the lock nuts to secure the lamp head in place.
* In TEST process, gently grasp the motion sensor and tilt it up or down to determine the
motion sensor detection zone.
Figure 4: Adjusting the lamp heads and motion sensor
* Set the power switch to the OFF position to turn the light off and to conserve the battery
life.
* Set the power switch to ON position to override the motion activation function. This will
allow turning the light constant on for a limited period during the day or night.
* Set the power switch to AUTO position to activate the motion detection function in test
and normal use mode.
Figure 5: Using the AUTO/OFF/ON power switch
Note: Prior to first use of your solar light, slide the power switch on the front of the light
fixture housing to the OFF position, allow the solar fixture to receive three full days of
sunlight to fully charge the battery.
Figure 3
Figure 4
Figure 5
