17
When connected, if the environmental brightness is not
enough, the lamp will turn on for approximately 60
seconds, and the RED LED will be blinking for
approximately 60 seconds to inform user to leave the
capturing area, then it is ready for operation and will begin
recording images once the motion sensor is triggered.
2.
Replacing the halogen lamp if faulty
CAUTION: The halogen lamp can be very hot.
a.
Always disconnect the power to your Security Light before
opening.
b.
Release the floodlight screw to open the floodlight cover.
c.
Carefully remove the Halogen lamp. It may be HOT.
d.
Insert a new Halogen lamp making sure you do not touch
the lamp with bare skin. Halogen Lamp: Maximum 300W
R7S
e.
Close the floodlight cover and screw together carefully.
Camera set up / getting started
1.
Inserting SD memory card
a.
Use the hexagon key to release the screw from front cover,
then rotate the front cover anti-clockwise to the end, and
take the front cover out.
b.
After opening the front cover, insert the SD memory card
into the SD card slot in the correct direction, as shown on
the inside of the housing.
1.
Do not force the SD card in
2.
Make sure that the SD card is unlocked
c.
To remove the SD memory card, push the SD card in and it
will spring out, now pull out the card gently.
Note:
SD cards must not contain any other images and you
must ensure that your Security Light is disconnected from AC
power when adding or removing an SD memory card. Failure
to observe these rules may result in malfunction and will void
the warranty.
