1
Preparing the canopy
2
Preparing the motor
3
Assembling the fan
Assembly
A
BB
BB
C
B
□
Remove the canopy ring (B) from the canopy (C).
□
Remove the two non-slotted mounting bracket screws
(BB) from the canopy (C), and loosen the slotted
mounting bracket screws (BB) on the canopy (C).
□
Remove the canopy (C) from the mounting bracket (A)
by turning the canopy (C) counterclockwise.
□
Remove the clevis pin (GG) and cotter pin (HH), and
loosen the two collar setscrews (KK) from the motor
collar.
□
Take out the setscrew (JJ) located in the hanger ball
(QQ), lower the hanger ball (QQ) and remove the
cross pin (II). Remove the hanger ball (QQ) from the
hanger ball/downrod assembly (D).
HH
GG
KK
KK
JJ
D
II
B
F
E
C
RR
KK
KK
GG
HH
JJ
II
□
Carefully feed the motor wires up through the
downrod (RR). Thread the downrod (RR) into the
collar.
□
Next, line up the holes and replace the cotter pin (HH)
and clevis pin (GG). Tighten the two collar setscrews
(KK).
□
Slip coupling cover (E), canopy ring (B), and canopy
(C) onto the downrod (RR).
□
Carefully reinstall the hanger ball (QQ) onto the
downrod (RR). Ensure that the cross pin (II) is in the
correct position, the setscrew (JJ) is tightened and
the wires are not twisted.
WARNING:
Failure to properly install the cotter pin (HH)
could result in the fan loosening and possibly falling.
NOTE:
If a longer downrod (not included) is needed, take
out the screw located in the hanger ball (QQ), lower the
hanger ball (QQ) and remove the pin (II). Remove all three
pieces from the downrod and assemble them onto the new
longer downrod before proceeding to the downrod installa-
tion.
8
