7
HOMEDEPOT.COM/HOMEDECORATORS
Please contact 1-800-986-3460 for further assistance.
Assembly - Standard Ceiling Mount
Routing the wires
Preparing for mounting
□
Remove the magnetic canopy bottom cover (DD) from the
canopy (C) by pulling it off.
□
Loosen the two canopy screws (CC) located in the bottom of
the mounting bracket (A).
□
Turn the mounting bracket (A) counterclockwise and lift it up to
remove the mounting bracket from the canopy (C).
□
Route the wires exiting the top of the fan motor assembly (E)
through the decorative motor collar cover (D) and then the
center of the canopy bottom cover (DD).
□
Make sure the opening of the canopy (C) is on top and insert
the ball/downrod (B) through the canopy (C).
□
Route the wires exiting the top of the fan motor assembly (E)
through the downrod as shown.
2
1
Assembling the fan
□
Loosen, but do not remove, the setscrew (EE) on the motor
collar (FF) on top of the fan motor assembly (E) by turning it
counterclockwise.
□
Install the downrod (B) by inserting it into the motor collar (FF)
and turning it clockwise until it is tight.
□
Re-tighten the setscrew (EE) on the motor collar (FF) on top of the
fan motor assembly (E) by turning it clockwise.
CAUTION:
To ensure wobble-free operation and to avoid
damage to the fan, the downrod (B) and the setscrew
(EE) must be completely tightened.
3
C
D
E
DD
B
C
A
CC
DD
NOTE:
This fan is equipped with a safety tab (GG).
Should the setscrew (EE) ever become loose while
the fan is running in reverse, the safety tab (GG) will
engage and stop the fan from falling.
E
B
EE
FF
GG