9
HOMEDEPOT.COM/HOMEDECORATORS
Please contact 1-800-986-3460 for further assistance.
Assembly - Hanging the Fan (continued)
Preparing the remote control
3
□
Remove the remote control (L) battery cover by pressing firmly on
the arrow and sliding the cover off.
□
Slide the dip switches (ZZ) to your choice of either up or down. The
factory setting is up.
□
Slide the dip switches (ZZ) on the receiver (K) to the same position
as set on the remote control (L).
□
Install the 23A 12V battery (included).
□
Replace the battery cover on the remote control (L).
□
Insert the silicone rubber stopper (OO) into the hole on the receiver
(K) to cover the dip switches.
NOTE:
The frequencies on your receiver and hand unit have been
preset at the factory. Before installing the receiver, make sure the
dip switches on the receiver and hand unit are set to the same
frequency. The dip switches on the hand unit are located inside the
battery compartment.
NOTE:
The remote control battery will weaken with age and
should be replaced before leaking takes place, as this will damage
the remote control. Dispose of used battery properly and keep the
battery out of the reach of children.
Installing the receiver
□
Position the house supply wires (AAA) to one side of
the slide-on mounting bracket (A); position the fan
wires (BBB) to the opposite side.
□
Insert the narrow end of the receiver (K) (as shown,
flat side towards the ceiling) into the slide-on
mounting bracket until it rests on top of the ball/
downrod assembly.
4
WARNING:
To reduce the risk of fire or electric shock,
remember to disconnect power. The electrical wiring
must meet all local and national electrical code
requirements. The electrical source and fan must
be 110/120 volts, 60Hz. Do not use this product in
conjunction with any variable wall control. Incorrect
wire connection can damage this receiver.
CAUTION:
If other fan wires are a different color, have
this unit installed by a licensed electrician.
L
K
ZZ
1 2
3 4
ON
OO
1
2
3
4
ON
YKO
1
2
3
4
ON
YKO
C
Receiver (K) correctly
positioned in
mounting bracket.
K
BBB
B
AAA
A
