STEP 7
Connect the Cable from the (H) Headlight to the top front of the (B) Gas Tank/Motor as shown in
Figure 1.
Now, plug the UL Power Adapter into the input receiving jack marked “DC 5.9V” on the (I) Function
Control Box as shown in Figure 2.
Note: Do not plug the UL Power Adapter into power outlet until item assembly is completed.
STEP 8
Lower the (L) Legs over the (B) Gas Tank/Motor as shown in Figure 1. Attach the (L) Legs by sliding
the forked-hook connector into the corresponding slots located on the pole of the (I) Function Control
Box as shown in Figure 2.
Assemble shoes to the (A) Base by aligning the hole located at the bottom of the shoes and sliding
them down onto the small poles located at the front of the (A) Base as shown in Figure 3.
STEP 9
Wrap the (M) Shirt around the neck and Secure the hook & loop closures as shown in Figures 1. & 2.
Set the (N) Coat on the (J) Shoulder Ring as shown in Figure 3.
STEP 10
Slide the (O) Right Arm up through the right sleeve of the (N) Coat and slide the forked-hook into the
right “shoulder” slot housing on the (J) Shoulder Ring as shown in Figure 1. Set the (P) Right Hand
into place by sliding the forked-hook into the “wrist” slot housing on the end of the (O) Right Arm as
shown in Figure 2. Locate the hook & loop closures at the right sleeve of the (N) Coat and secure to
the hook & loop closure at the wrist as shown in Figure 3.
Align the hole on inside of the (P) Right Hand over the end of the right side of the (G) Handle Bars and
slide down to attach and secure, as shown in Figure 4.
3/5
B
H
I
L
L
B
L
I
M
M
A
1
2
1
2
3
K
K
N
N
1
2
3
1
3
4
2
O
O
P
P
P
G
J
Sensor / D
étec
teur
5.9 V
Try me / Essaie
-moi / P
ruébame
STEP HERE
(Not Included)
ADAPTER
OPTIONAL:
If you choose to use the Step Here
Try-Me Activation Pad, plug the connector into
the input receiving jack marked “TRY ME” on
the Function Control Box and set the Step Here
pad in front of the character when ready to
display.
