HomComfort HCPHWKR, Руководство пользователя

Страница: 8 / 24

8
A. Turn the Control Knob to switch to desired temperature position.
Note: If a new tank has just been connected, please allow at least one minute for the air in the gas pipeline to
purge out at the pilot position. A 5-minute complete shutoff period is necessary before relighting.
If you experience any ignition problem please consult “Troubleshooting”.
Caution: Avoid inhaling fumes emitted from the heater’s first use. Smoke and odor from the burning of oils used
in manufacturing will appear. Both smoke and odor will dissipate after approximately 30 minutes. The heater
should NOT produce thick black smoke.
Note: The burner may be noisy when initially turned on. To eliminate excessive noise from the burner, turn the
Control Knob to the Lo position. Then, turn the knob to the level of heat desired.
WHEN HEATER IS ON
Emitter screen will become bright red due to intense heat. The color is more visible at night.
Burner will display tongues of blue and yellow flame. These flames should not be yellow or produce thick black
smoke, indicating an obstruction of airflow through the burners. The flame should be blue with straight yellow
tops.
If excessive yellow flame is detected, turn off heater and consult “ Troubleshooting”.
RE-LIGHTING
Note: For your safety, Control Knob cannot be turned OFF without first depressing
Control Knob in Hi position and then rotating it to OFF.
• Turn Control Knob to OFF.
• Wait at least 5 minutes, to let gas dissipate, before attempting to relight.
• Repeat the “Lighting” steps.
SHUT DOWN
• To Shut Down, depress Control Knob and continue to turn it clockwise to OFF. (Normally, burner will make a
slight popping sound when extinguished.)
• Turn Cylinder Valve clockwise to OFF and disconnect Regulator when heater is not in use. Note: After use,
some discoloration of the emitter screen is normal.
Operation
WARNING
FOR YOUR SAFETY
Be careful when attempting to manually ignite this heater. Holding in the control knob for more than 10
seconds before igniting the gas will cause a ball of flame upon ignition.
WARNING
FOR YOUR SAFETY
Heater will be hot after use. Handle with extreme care.