-12-
STORAGE BETWEEN USES
• Turn the control knob off.
• Disconnect the LP source.
•
Store the fire pit in an area sheltered from direct contact with inclement weather (such as rain, sleet, hail,
snow, dust and debris).
•
If desired, cover the fire pit to protect exterior surfaces and to help prevent build-up in air passages.
Note: Wait until the fire pit is cool before covering.
STORAGE DURING PERIODS OF EXTENDED INACTIVITY OR WHEN TRANSPORTING
• Turn the control knob off.
• Disconnect LP source and move to a secure, well-ventilated location outdoor.
•
Store the fire pit in an area sheltered from direct contact with inclement weather (such as rain, sleet, hall,
snow, dust and debris).
•
If desired, cover the fire pit to protect exterior surfaces and to help prevent build-up in air passages.
• Never leave the LP cylinder exposed to direct sunlight or excessive heat.
Note: Wait until fire pit is cool before covering.
SERVICE
Only a qualified service person should repair gas passages and associated components.
Caution: Always allow the fire pit to cool before attempting service.
PROBLEM
POSSIBLE CAUSE
CORRECTIVE ACTION
Burner won’t light
Propane cylinder is empty
Replace propane cylinder
Blockage in orifice
Clear blockage
Control knob is not in “ON” position
Turn control knob to “ON”
Burner flame is low
Gas pressure is low
Turn cylinder valve off and re-fill the cylinder
Outdoor temperature is less than 40°F
and tank is less than 1/4 % full
Use a full cylinder
Control knob fully on
Check burner and orifices for blockage
Carbon build-up
Dirt or film on burner
Clean burner
Thick black smoke
Blockage in burner
Remove blockage and clean burner inside and outside
Troubleshooting
Содержание HCFTALOAK
Страница 14: ... 14 Notes ...
Страница 19: ... 14 Remarque ...