9
EN: ESPRESSO MAKER |
Instruction Manual
FROTHING MILK/PRODUCING STEAM TO HEAT LIQUIDS
The steam wand can be used to froth milk and make hot beverages like drinking chocolate, water or tea.
METHOD:
1. Remove the removable tank and fill it with desired water, the water level should not exceed the “MAX” mark in the tank.
Then insert the tank into the appliance properly.
2. Then connect the appliance to power supply.
3. Press down the ON/OFF button “
” to turn on the unit, the power indicator (red) illuminates.
4. Press down the pump control button “
” to the lower position, make sure the coffee/steam button “
” is at the
higher position, the pump will pump water, when there is water flowing out, close the pump immediately.
5. Press down the coffee/steam button“
” to the lower position and wait for a moment, the appliance begins to heat until
the (green) lamp illuminates, it means the heating is finished.
6. Dip the steam wand into the liquid to be heated. If you want to froth milk, dip the steam wand about 2 centimeters into the
milk. Turn the steam knob in anti-clockwise slowly to start making steam.
7. Then the desired result is got, you can turn the steam knob to the “O” position.
8. Please follow the operation as below to avoid the steam outlet being blocked after finish frothing milk each time: put an
empty jug under the steam band, then turn on the steam knob and press down the pump control button “
” to the lower
position, the pump will pump water, after the water flowing out for 30 seconds, press the pump control button “
” to the
higher position, finally, clean the steam outlet with wet sponge, but care not to be burnt!
9. Press and release the ON/OFF button “
” to cut off the power source.
NOTE:
Please follow the operation as below if the steam outlet is blocked: firstly turn the steam knob to “O” position and
make the coffee maker cool down for about half an hour, then poke the steam outlet for several times with a needle about
1mm in diameter, finally, press down the coffee/steam button “
” and turn on the steam knob to check if the appliance can
produce steam normally when the steam indicator (green) illuminates. Please contact the service department if the appliance
can not produce steam after operate as above.
NOTE:
after steaming, we recommend you allow the maker to cool down at least for 5 min before making coffee again.
Otherwise burnt odor may occurred in your Espresso coffee. If you want to make coffee immediately, follow the next steps:
First, press and release the steam button “
” to the higher position; dip the steam wand into a cup; secondly, press the
pump control button “
” down to the lower position and turn on the steam control knob and there will be water flow
out from steam wand ; after the ready indicator extinguish, press and release the pump control button “
” to the higher
position, then turn the steam control knob to “O” position. When the ready indicator illuminate, you can start to brew coffee again.
AUTOMATIC POWER OFF FUNCTION
The appliance will turn off automatically if there is no any operation within 29 minutes.
