Holzstar TKS 200, Инструкция по эксплуатации, Страница: 13 / 34

Set up before commissioning
TKS Serie | Version 1.04 13
Step 2: Place the sliding carriage on the carrier and fa
-
sten it.
Fig. 14: Mount sliding carriage
Mount suction connection and protective devices
Step 1: Screw the exhaust port at the bottom of the back
of the machine with 4 M6x12 Phillips screws,
washers, and nuts (nuts on the inside).
Fig. 15: Mount suction connection
Step 2: Screw on the saw blade guard.
Fig. 16: Mount saw blade guard
Step 3: Screw the hose guide to the back of the steel ta
-
ble with 2 M6x20 hexagon bolts, washers and
nuts (nuts on the inside of the table).
Fig. 17: Mount hose guide
Mount suction hoses
Fig. 18: Mount suction hoses
Fig. 19: Mount suction hoses
Step 1: Attach the 30mm suction hose to the saw blade
guard with a hose clamp, then insert the hose
into the hose guide. Make sure that the hose
runs freely and that there is enough clearance
to the work surface.
Step 2: Attach the other end of the suction hose to the
suction connection on the machine housing
with a hose clamp.