Holzstar 5900255, Инструкция по эксплуатации, Страница: 5 / 24

3.1 Specifi ed conditions of use
• This machine is intended to rip and crosscut
grown timber, faced boards, chip board
and wood-core plywood sheets, and similar
wood-derived materials.
• Do not cut round stock without suitable jigs
or Þ xtures. The rotating saw blade could
turn the workpiece.
• When sawing thin stock layed on edge, a
suitable guide must be used for Þ rm support.
Use of wobble saw blades is not permitted
on this machine.
Danger! Any other use is not as speci Þ ed.
2. Please Read First!
• Read these instructions before use. Pay
special attention to the safety instructions.
•
Do not
operate the saw if you notice
transport damage while unpacking! Notify
your supplier immediately.
• Dispose the packing in an environmentally
friendly manner. Take to a proper collecting
place.
• Keep these instructions for reference on any
issues you may be uncertain about.
• If you lend or sell this machine, be sure to
have the instructions go with it.
3. Safety
• Use not as speci Þ ed, alteration of the
saw or use of parts that are not approved
by the equipment manufacturer can cause
unforeseeable damage!
3.2 General safety instructions
• Observe the following safety instructions
when operating this table saw, to exclude
the risk of personal injury or material
damage.
• Observe the special safety instructions in
the respective chapters. Keep all enclosed
documents for future reference.
• Observe the statuary accident insurance
institution regulations and regulations for
the prevention of accidents pertainning to
the operation of table saws, where
applicable.
General Hazard!
• Keep your work area tidy – a messy work
area invites accidents.
• Be alert. Know what you are doing. Set out
to work with reason. Do not operate the saw
under the in
ß uence of drugs, alcohol or
medication.
• Consider environmental conditions.
• Keep work area well lighted.
• Prevent adverse body positions. Ensure
Þ rm footing and keep your balance at all
times. Use suitable workpiece supports
when cutting long stock. Do not operate the
saw near in
ß ammable liquids or gases.
• The table saw shall only be started and
operated by persons familiar with it, and
who are at any time aware of the dangers
associated with the operation of such tool.
• Persons under the age of 18 years shall
operate the saw only in the course of their
vocational training, under the supervision of
an instructor.
• Keep bystanders and particularly children
out of the danger zone. Do not permit other
persons to touch the saw or power cable
while it is running.
• Do not overload the saw – use it only within
the performance range it was designed.
Danger! Risk of electric shock!
• Do not expose the saw tool to rain.
• Do not operate the saw in damp or wet
environment.
• Prevent body contact with earthed objects
such as radiators, pipes, cooking stoves,
refrigerators when operating this saw.
• Do not use the power cable for purposes it
is not intended for.
Risk of personal injury and crushing by
moving parts!
• Do not operate this machine without
installed guards.
• Always keep suf Þ cient distance to this saw.
Use suitable feeding aids, if necessary.
• Keep suf Þ cient distance to motor and driven
components when operating this machine.
Insure it is disconnected from power supply
before servicing.
5