Holzstar 5900255, Инструкция по эксплуатации, Страница: 16 / 24

6, Loosen the saw blade spindle arbor nut
with spanner (L.H. thread!).
7, Take the outer blade collar and saw blade
off the saw spindle.
8, Clean clamping surfaces of the saw
spindle and the saw blade.
Danger!
Do not use cleaning agents (e.g. for removing
resin residue) that could corrode the light
metal components of the machine; the
stability of the machine might be adversely
affected.
9, Put on a fresh saw blade.
Danger!
Use only suitable saw blades – when using
unsuitable or damaged blades, parts could be
explosive like hurled from it by the centrifugal
force.
Do not use:
- saw blades with visible damage;
- cut-off wheel blades.
10, Slide the outer blade collar onto the saw
pindle.
11, Screw the arbor nut, with the low side
facing the blade, onto the saw spindle
(L.H. thread!).
Danger!
- Do not extent the arbor nut wrench.
- Do not tighten arbor nut by tapping on the
wrench.
- Do not forget to remove the saw spindle
lock bar after tightening the arbor nut!
- Keep surfaces of saw table and saw base
clean.
12, Loosen screw (a) of the riving knife
bracket.
13, Adjust the distance between the edge of
the saw blade edge and the riving knife (b).
It must be 3-8mm. (Figure 31)
14, Reinstall the cover plate and blade guard.
Figure 31
8.2 Cleaning the saw
1, Lay machine on its side.
2, Remove chips and saw dust with the
vacuum cleaner or brush:
- from saw blade setting guide elements
- from travelling sizing table guide elements
- from motor vent slots
8.3 Machine storage
Danger!
Store the machine so that
- it can not be started by unauthorized
persons, and
- nobody can get hurt.
Caution!
Do not store the machine unprotected
outdoors or in damp environment.
8.4 Maintenance
• Before switching on
- Visual check if distance between the saw
blade and the riving knife is 3-8 mm.
- Visual check of power cable and power
cable plug for damage. If necessary, have
the damaged parts been replaced by a
quali
Þ ed electrician.
• Monthly (if used daily)
- remove the saw dust and chips with the
vacuum or brush. Apply light coat of oil to
guide elements:
- threaded rod and guide rods of the blade
rise and fall mechanism;
- swivel segments.
16