Holzstar 5900255, Инструкция по эксплуатации, Страница: 12 / 24

Be sure the safety switch is placed in
the correct position (Hole A) of the sliding
carriage. (Figure 18 - 1) Otherwise the ma-
chine can not be switched on.
The safety switch may ensure the
Machine not to run in case of the sliding
carriage moving and prevent people from
been injured by the saw blade.
C
Figure 17
Figure 18 - 1
Safety Switch
Hole A
3, Assemble the lock handle (A) to the sliding
carriage by by 1-M12 Nut. (Figure 19)
Assembly the sliding carriage handle by
insert the square nut into the T-Slot of the
sliding carriage. Turn colockwise to
Þ x it.
(Fugure 20)
Figure 19
A
M12 Nut
Handle
Square Nut
Figure 20
Limiting Screw
Support Plate
Sliding Carriage
Safety Switch
Be sure to position the limiting screw next
to the support plate. It will help to correctly
position the sliding carriage. (Figure 18 - 2)
Figure 18 - 2
Check the surface alignment of the major
table and the sliding carriage. Adjust gurb
screws on the support plate for micro
adjustment. (Surface Alignment - 1)
Grub Screw
Surface Alignment - 1
4, Take out the sliding table frame (A) and the
support bracket (B) from the master case.
Attach the support bracket to the sliding
table frame by 2-M8 mm carriage bolts and
2-M8 mm nuts with washers. (Figure 21)
Do not move the M20 nuts in the other
end of the support bracket.
Figure 21
A
B
M20 Nut
12