Holzmann SB 3116RHN, Руководство пользователя

Страница: 10 / 35

www.holzmann-maschinen.at
Unpack and separate all parts from packaging material and check if the delivery content
is complete. For checking refere to Fig. 3, Fig. 4 and Fig. 5 .
Please report eventual missing or damaged parts immediately to your reseller.
Later claims from transport damage cannot be accepted anymore.
DELIVERY CONTENT
Assembly hardware is located in one box
and one bag. Each contains the necessary
parts for each assembly step. Remove all
packing and protective material from the
Drill Press components. To aid in assem-
bly, refer to the Assembly Drawing Fig. 2
as well as to the parts drawings at the end
of this manual. The machine assembly is
shown on basis of the model SB 3116RHN.
1. Position the Base (B6) on a level and
sturdy floor for mounting.
Bolt the Base to the floor using appropri -
ate hardware (not supplied). Base holes
will accommodate 7/16 inch bolts. Pull out
the Wire Stabilizer (B21) rod from the rear
of the Base.
2. Place the Column Support (B4) on the
Base, aligning the mounting holes.
ASSEMBLY
3. SETUP
3. Insert four large Hex Screws (B5) into
the mounting holes and tighten with a
wrench.
4. Insert the Column (B1) into the Column
Support (B4) and secure with Screw (B3).
5. Install the Table Support (B7), with at-
tached table Arm (B14), over the Column
(B1) and slide it down. Engage the ge-
ars onto the Rack (B2). Tighten the Table
Clamp (B13).
6. Slide the Column Collar (B19) over and
down the Column (B1) about 8 inches.
Tighten Screw (B11).
7. Place the Extend Arm (B15) into the
Arm (B14), and then the Table (B20) into
the opening in the Extend Arm.
Abb. 2/Fig. 2